Description

🏠 ATE LC30 Black – Wall Drying System Against Humidity

Wall drying – The effective electromagnetic solution against capillary moisture

Humidity in walls is a common problem, often linked to rising damp: water contained in the ground naturally rises through porous materials (brick, stone, mortar, render). This phenomenon can lead to damp walls, mold, salt deposits, aesthetic damage, and thermal discomfort.

This system is a wall damp-proof device designed to help with the drying of damp walls and the treatment of rising damp, without chemical injections and without invasive work. Thanks to its electromagnetic polarity inversion technology, it acts at the source of the issue and supports gradual action over time on moisture in masonry.

⚙️ How does the ATE LC30 work?

Each wall generates a natural electrical potential difference that attracts moisture upward. It emits low electromagnetic impulses at very low frequency that reverse the polarity of these fields: water molecules then move back down into the foundations by gravity.

This process works continuously, silently, autonomously, and without maintenance.

✅ Benefits of the ATE LC30 Black model

Operating radius: 15 meters (30 m diameter)

Passive treatment with no invasive work

No vibration, no noise, no harmful emissions

Low consumption: only 0.75 W (≈€15/year)

Discreet device with matte black design

10-year manufacturer warranty

Made in France

Certified compliant with European standards (EMF, RoHS, EMC…)

ATE LC30 User Manuals

Download the manual in your language:

French – Download the manual

English – Download the manual

German – Download the manual

Italian – Download the manual

Portuguese – Download the manual

Spanish – Download the manual

📦 Technical specifications

Dimensions: 322 x 232 x 32 mm

Voltage: 12 V

Power consumption: 0.75 W

Maximum coverage: 30 m diameter

Installation: unit to be fixed on a load-bearing wall

Certifications:

Directive 2014/35/EU (Low Voltage)

Directive 2014/30/EU (EMC)

Directive 2011/65/EU (RoHS)

Directive 2012/19/EU (WEEE)

EMF tested by Emitech laboratory (non-harmful waves)

🎯 Results and effectiveness

By following our recommendations, significant drying is generally observed within 18 to 24 months, depending on the building structure, wall condition, and correct application of the guidelines.

A dry wall also recovers its natural insulating capacity, which helps reduce heating needs.

🛠️ Our installation recommendations

Installation height: between 30 cm and 1 m from the floor on a load-bearing wall or structural partition wall only

Distance: at least 1.50 m from any electronic device

Fixing: hang it on the wall like a frame, without moving it afterward

Permanent connection: the device operates continuously (very low consumption)

💡 Tips to optimize drying

Remove film-forming coatings 10 to 20 cm above damp areas

Ventilate properly: install mechanical ventilation, air vents, or check door undercuts

After drying: brush hygroscopic salts off the surface, then redo plaster with an anti-salt additive

Drain if needed: if the wall is subject to lateral infiltration, installing drainage is recommended

⚠️ Please note

This process does not treat:

Pressurized water infiltration (e.g., roof leaks, flooding)

Mold already present on surfaces
These issues must be handled separately.