Comparing wall drying devices and seeing coverage expressed in metres? Before choosing, check whether the figure is a radius or a diameter. Humidité Conseil recommends reading this information alongside the building plan to prepare a consistent selection.
Check the units before comparing
Radius measures the distance from the centre to the edge of a circle; diameter crosses the circle through its centre. A value in metres is not an area in square metres. To compare two descriptions, check that they use the same quantity. Then mark the stated coverage on a simple plan, starting from the proposed device position.
Consider your building layout
The arrangement of rooms and available installation positions form part of the assessment. Do not choose a model just because a number looks larger. Also check the technology, power connection and applicable instructions. A wall drying device should be considered for identified rising damp; it does not replace repairing water ingress. Clarify the model specifications before buying.
ATE LC30: a model to explore
ATE LC30 is presented with a coverage diameter of 30 metres. Consider this figure alongside the proposed position and the building layout. Read the product page for specifications, documentation and ordering conditions. Its mains supply distinguishes it from the autonomous ATG range: choose using the information for each product.
Explore our devices and prepare your choice
Compare the devices on Humidité Conseil and prepare your choice with clearly defined dimensions and an installation position.
Check the intended use
The device being considered must be appropriate for rising damp. Selection, installation and monitoring should be prepared according to the model instructions and the building layout.
Choose and order my device · Discover ATE LC30 · Ask for product advice
Watch the ATE installation video